CreativePro Forum

Return to Member Forum

• Author
  Posts
• • December 13, 2017 at 8:19 am #100311
    swen2

    Member

    After updating 2 days ago to latest Windows 10, which always presents some sort of problem, when we open a file printed previously the printing properties are not held and changes made in the driver are not held. If I print to another printer and then print to the original printer, the settings will stick. If I am starting a new file, there is not an issue with the settings holding. Same if I open a file previous to when we installed the printers we use now. Printing from ID CS6 only is the problem.

  • December 13, 2017 at 11:57 am #100317
    swen2

    Member

    The procedure we do is:
    Print (choose printer)
    setup
    Preferences
    Choose options in driver (ie – duplex, tray, etc)
    Print
    Print again to send to printer

    If you stop at the next to last Print command, and go back to check your options in the print drive – they did not stick or hold.

    If we choose another printer and proceed as follows, but stop short of the last print command, then choose the original printer and the options will now hold.

    I hope that better explains what is going on…

    Any solutions to try?

• Author
  Posts